![]() ![]() If applied during the heat of the day, the sealer may "flash", and create an unwanted coloration. Sealer should be applied when it is cool, such as in the early morning or early evening. Pool Deck Resurfacing After Sealant Applied For best results, contact a professional with experience in color-matching. Note: It is not recommended for D-I-Y homeowners to attempt to match the underlying stain on the replacement concrete section before applying the final stain to the entire pool deck. You will not need to use a compass.)Ĭoats of stain were applied in order to assure that the stain fully andĮvenly covered the concrete's porous surface to prevent unwanted light (The north-south and east-west directions are only to helpĮxplain the two cross-hatched directions in which the stain was rolled The second coat was rolled on in the opposite direction, (east to As an was rolled (north to south), andĪllowed to fully dry to the touch. The first coat was rolled in oneĭirection, only. Plastic, and the stain was hand painted with a brush on the inner copingĪrea to assure that no stain would get into the water.Ĭoats of stain were rolled on. Interior pool coping area (next to the water) was taped off with However, with the pool's interior being in such close proximity to theĬoncrete which needed to be stained, the stain was rolled on. Stain can also be sprayed onto a concrete surface, Terracotta colored water-based concrete stain was then rolled on withĪ 5/8" nap roller. Drying Time - The concrete was then allowed to fully dry for several days. Naked eye) may affect the overall uniformity of color of the stainedĬoncrete surface, and not provide you with your hoped-for results fromĪll your hard work. Mildew, mold or dirt (even if you can't see any of this debris with the Keep in mind that stain colors are PERMANENT. ![]() If youĪre a Do-It-Yourselfer, commercial-grade pressure washers are availableįor rental from an equipment rental store. The pressure washer used on this pool deck was 3,400 PSI. ![]() ConcreteĬontractors use high pressure washers, typically between 2,000 - 3,500 The average water pressure from a home water faucet is about 40 to 80 PSI. Remove mildew, mold or ground in dirt, or fertilizer acids which areīetween the sand particles within the concrete's top surface. The water pressure provided by most garden hoses is insufficient to Washing provides a much cleaner surface area than using a garden hose. Before stain was applied, the pool deck was pressure washed to removeĪny dirt, sand, and debris so that the concrete deck's surface wouldĪccept the stain, uniformly. Tips For D-I-Y (Do It Yourself) Pool Deck ResurfacingĬhoose A Two-day Period Without Rain Before Applying Stain Pressure Wash ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |